Mounting Variant A: Clamping In The Helmet Adapter With Tabs - TILSBERK DVISION Manual De Instrucciones

3.3 Mounting variant A: clamping in the helmet adapter with tabs

Video instructions
Detailed video instructions for installing DVISION in helmets without sun visors are available on the
internet. To access, scan the QR code or call up the video via the browser link.
dvision-hud.com/install/a
Required components
For this mounting type, you need the following components from the scope of delivery:
// DVISION module
// DVISION helmet adapter with tabs
Installing the helmet adapter
3
FIGURE 9 //
Clamping in the helmet adapter with tabs
1. Place the helmet adapter (FIGURE 9/1) in the forehead section of the helmet. At the front of the
helmet adapter, there is a mark (FIGURE 9/2) that should be placed on an imaginary line between
the middle of your helmet and the middle of your face.
2. Use both hands to evenly push the tabs into the gap (FIGURE 9/3), until the base plate of the
helmet adapter is flush on the mounting surface of the helmet. For some helmets, the gap needs
to be pulled open a bit first.
1
INFO
If you notice that individual tabs collide with the helmet material in the
gap in the helmet, you can simply break off up to three tabs (FIGURE 9/4,
for example). The helmet adapter is perforated at the lower edge of the
tabs (FIGURE 9/5) to facilitate break off. You may use a file or scissors to
smoothen the breaking points a little.
I N - H E LM E T I N STA L L AT I O N
2
EN
5
4
19