TILSBERK DVISION Manual De Instrucciones página 21

Checking the position of the helmet adapter
3. Put your helmet on as usual.
4. Attach the DVISION module to the helmet adapter using the magnets and fold down the display
at a 45° angle.
The display should be well visible in front of your right eye.
5. Push the operating button on the DVISION module to switch on the device.
A screen appears on the display.
6.
7. If the display is fuzzy or hard to read, you can change the angle of the display slightly.
8. If the frame shown on the display is fully or partially outside your field of vision, remove the
DVISION module and the helmet adapter from the helmet and slightly move the helmet adapter
in the desired direction.
9. Always recheck the conditions listed in step 6 and keep adjusting the position of the helmet
adapter until all conditions are met.
You have mounted the helmet adapter with tabs in the helmet. Proceed by setting up
the DVISION app ("Installing and setting up the DVISION app" on page 33).
Check if you can clearly see everything on the display in its entirety
without changing the position of the helmet on your head. To do so, look
ahead as you would if you were riding in traffic:
// The display should be well visible in front of your right eye.
// The display should be clear and easy to read.
// The entire screen should be within your field of vision. Use the frame
for orientation when switching on the DVISION module.
INFO
You can show the frame again for alignment orientation at any time.
To do so, activate "Alignment mode" in the "Settings" menu.
I N - H E LM E T I N STA L L AT I O N
EN
20