TILSBERK DVISION Manual De Instrucciones página 32

15. Check if you can clearly see everything on the display in its entirety
16. If the display is fuzzy or hard to read, you can change the angle of the display slightly.
17. If the frame shown on the display is fully or partially outside your field of vision, remove the
DVISION module and the helmet adapter from the helmet and slightly move the helmet adapter
in the desired direction.
18. Always recheck the conditions listed in step 15 and keep adjusting the position of the helmet
adapter until all conditions are met.
without changing the position of the helmet on your head. To do so, look
ahead as you would if you were riding in traffic:
// The display should be well visible in front of your right eye.
// The display should be clear and easy to read.
// The entire screen should be within your field of vision. Use the frame
for orientation when switching on the DVISION module.
INFO
You can show the frame again for alignment orientation at any time.
To do so, activate "Alignment mode" in the "Settings" menu.
INFO
Shortly after mounting, the Sugru has not yet developed its full adhesive
power. The helmet adapter can be removed easily and then attached
again. If the layer of Sugru changes shape when the helmet adapter
is removed from the helmet, flatten it with your fingers prior to re-
mounting.
I N - H E LM E T I N STA L L AT I O N
EN
31