Mounting Variant C: Using An Adhesive Pad To Glue In The Narrow Helmet Adapter - TILSBERK DVISION Manual De Instrucciones

3.5 Mounting variant C: using an adhesive pad to glue in the narrow helmet adapter

Video instructions
Detailed video instructions for installing DVISION in helmets using adhesive pads are available on
the internet. To access, scan the QR code or call up the video via the browser link.
dvision-hud.com/install/c
Required components
For this mounting type, you need the following components from the scope of delivery:
// DVISION module
// DVISION helmet adapter narrow
// Adhesive pad for DVISION helmet adapter narrow
Installing the helmet adapter
FIGURE 11 //
Using an adhesive pad to glue in the narrow helmet adapter
1. Apply the adhesive pad (FIGURE 11/1) to the side of the helmet adapter on which you can see the
magnets.
2. Place the helmet adapter (FIGURE 11/2) in the forehead section of the helmet, between the inner
shell and the outer shell (FIGURE 11/shown in red). There is a mark at the bottom of the helmet
adapter (FIGURE 11/3) that should be placed on an imaginary line between the middle of the
helmet and the middle of your face (FIGURE 11/dotted line). Make sure the helmet adapter does
not collide with the sun visor.
I N - H E LM E T I N STA L L AT I O N
1
2
3
EN
24