Pit Boss PRO Serie Montaje Y Operación página 13

17. INSTALLING THE COOKING COMPONENTS
Parts Required:
1 x Heat Deflector Plate (#2)
1 x Water Pan (#3)
Cooking Grates (#1)
5 x
Installation:
• Place the Heat Deflector Plate over the burn pot at the bottom of
the interior main cabinet. To ensure proper positioning, align into the
grooves along the bottom of the base panel. Note illustration 17A.
IMPORTANT: If the heat deflector plate is not installed correctly it
will cause damage to the control board if the flames are too large.
• Next, insert the water pan into the lowest embossed grid supports of
the interior cabinet. Fill your water pan about ¾ full of water.
IMPORTANT: Keep water in the water pan at all times while cooking.
It will catch grease and drippings from your cooks and allow for
easier clean up. If smoking for an extended period of time, move
water pan up higher to allow water to last longer.
• Last, place the cooking grates on the embossed grate supports inside
the main cabinet. Note illustration 17B.
• The unit is now completely assembled.
18. CONNECTING TO A POWER SOURCE
NOTE: Disconnect when not in use.
• STANDARD OUTLET
This unit requires 110-120 volt, 60Hz service. It must be a 3-prong grounded
plug. Ensure grounded end is not broken off. The control uses a fast-blow
fuse to protect the board from the igniter.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity
which can be too much power for a GFCI outlet to handle. The quality
of the GFCI does not matter, but rather the sensitivity; each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
•
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. A Pit Boss unit can operate using a 12 volt, 100 watt
inverter plugged into your automobile outlet. To use the automatic
igniter, it is recommended to use a minimum of a 1000 watt inverter.
IMPORTANT! Once the shut-down cycle is complete, unplug the power cord.
17A
2
17B
1
2
3
18
FAST-BLOW FUSE
13