Continuous Mode; Cleaning Your Nebulizer - Trudell Medical International AeroEclipse XL Manual De Instrucciones

2. Place the MOUTHPIECE
EXHALATION VALVE
cover the
from functioning properly.
3. Inhale slowly and deeply. As you inhale, the
(Fig. 1) will move down, indicating that the reusable AEROECLIPSE* XL BAN is producing aerosol in
response to your inhalation.
4. Exhale normally through the device. The valve on the mouthpiece only opens during exhalation to allow air
to exit the device. This helps prevent re-breathing of exhaled air. During exhalation, the
BUTTON
returns to the up position indicating no aerosol is being produced (Fig. 5).
5. Continue to breathe normally through the device until it begins to make a 'sputter' noise or as instructed by
your healthcare professional.
6. Switch off the compressor when finished with your treatment.
NOTE: If you are unable to trigger the device during inhalation (unable to get the
BUTTON
to go down when you breathe in) it can be manually operated with your index finger by depressing/
GREEN FEEDBACK BUTTON
releasing the
switch the device to

CONTINUOUS MODE

MODE SELECTOR
Ensure the
CONTINUOUS Mode, the nebulizer may be used with the reusable ComfortSeal* Mask.
In
1. While sitting in a comfortable, upright position, switch on your compressor.
2. Mouthpiece: Place the
Be careful not to cover the
prevent the valve from functioning properly.
Mask: Place the mask securely over your nose and mouth, ensuring you have a good seal with the edge of
the mask and face. Even tiny gaps may affect medication delivery.
3. Inhale slowly and deeply. The
treatment, indicating the device is constantly producing aerosol. (Fig. 5)
4. Exhale normally through the device. The
allowing air to exit the device.
5. Continue to breathe normally through the device until it begins to make a 'sputter' noise or as instructed by
your healthcare professional.
6. Switch off the compressor when finished with your treatment.

CLEANING YOUR NEBULIZER

Ensure you clean your nebulizer before first use and between each treatment.
• For optimum performance you should replace your nebulizer every 6 months.
1. PREPARATION
Immediately after each treatment, all parts of the reusable AEROECLIPSE* XL BAN (excluding tubing)
must be cleaned of medication residue and contamination.
To do this, disassemble nebulizer as follows:
MODE SELECTOR
Rotate the
1.1
movement of the parts.
Remove the EZ Twist
1.2
Unscrew and remove the
1.3
For re-use at home, continue to read starting with Section 2.
EN 4
in your mouth, ensuring your lips are sealed around the edge. Be careful not to
on the bottom of the MOUTHPIECE, as doing so will prevent the valve
CONTINUOUS MODE
CONTINUOUS
is in
MOUTHPIECE
EXHALATION VALVE
GREEN FEEDBACK BUTTON
EXHALATION VALVE
to the
TUBING
from the bottom of the nebulizer.
NEBULIZER TOP
GREEN FEEDBACK BUTTON
in coordination with your breathing. Alternately, you may
( – Fig. 2).
position ( – Fig. 2).
in your mouth, ensuring your lips are sealed around the edge.
on the bottom of the MOUTHPIECE, as doing so will
BREATH ACTUATED
MOUTHPIECE
and remove
on the top of the nebulizer
GREEN FEEDBACK
GREEN FEEDBACK
will stay down for the duration of the
MOUTHPIECE
on the
position before cleaning to ensure free
from the
or Mask will open
NEBULIZER CUP.