Luminance Brands Kathy Ireland Home PRO Serie Manual Del Propietário página 5

Your ceiling fan is designed to be installed either in the standard manner, or in the
close-to-the-ceiling manner. Using the standard method, the hanger ball/downrod assembly will suspend
the fan several inches below the ceiling cover. Using the close-to-the-ceiling method, the ceiling cover
installs directly on the fan motor housing, thus mounting the fan 3-1/2 inches closer to the ceiling than the
standard method. In no case should the fan blades be lower than seven feet above the floor. Depending
on your desired mounting method, proceed to "INSTALLING HANGER BALL/DOWNROD ASSEMBLY" for
standard mounting, or to "INSTALLING CEILING COVER ON FAN MOTOR HOUSING" for close-to-the-
ceiling mounting.
3. Installing the Hanger Ball/Downrod Assembly
3.1
Pass the Motor Wires through the Opening in the
Ceiling Cover .
Be sure the Cover is Oriented Correctly (Figure 1) .
NOTE: Motor Wires Vary in Length, Depending on
the Model:
CF710 Ceiling Fan: 42" Motor Wires
CF711 Ceiling Fan: 80" Motor Wires
3.2
Separate, Untwist and Unkink the Three Motor Wires .
Route the Motor Wires through the Hanger Ball /
Downrod Assembly (Figure 2) .
All manuals and user guides at all-guides.com
IMPORTANT
(For Standard Mounting)
5
Figure 1
Figure 2
Please contact 1-800-777-4440 for further assistance
MOTOR
WIRES (3)
CEILING
COVER
MOTOR
WIRES (3)
HANGER
BALL/3.5"
DOWNROD
ASSEMBLY
luminancebrands.com
U.L. Model No.: 42-ANT & 52-ANT