Bosch KTS 250 Manual Original página 10

en | 10 | KTS 250
3.4 KTS 250 overview
2
 1: KTS 250
(1) Power key
(2) TFT touchscreen
---Separator---
3.5 Symbols on the rating plate
Attention: general warning sign indicating
danger. Before commissioning, connecting
and using Bosch products, it is essential to
read the operating instructions and the safe‐
ty instructions, in particular, carefully.
---Separator---
Dispose of used electrical and electronic de‐
vices, including cables, accessories and bat‐
teries, separately from household waste.
---Separator---
EU declaration of conformity
---Separator---
US declaration of conformity
---Separator---
The KTS 250 may only be used by trained
and instructed workshop personnel. The
KTS 250 is not suitable for installation and
use by end consumers as improper installa‐
tion or use may lead to the vehicle behaving
incorrectly while driving and cause severe in‐
jury or death.
---Separator---
Certification for Ukraine
---Separator---
Certification for the Russian Federation
---Separator---
Certification for Australia
---Separator---
Recycling of the portable battery for Japan
Li-ion
---Separator---
1 689 989 370 | 2022-01-08
3.6
The OBD connection cable is used to connect the
KTS 250 to the vehicle. Operation is by hand using the
TFT touchscreen and the on-screen keyboard. While the
device is connected to the vehicle by OBD interface, it
is possible to perform a control unit diagnosis and to
read the OBD fault memory of the vehicle. An external
printer (optional accessory) connected by WLAN can be
used to print the data and measured values. The
KTS 250 and the accessories are supplied in a protec‐
tive case.
---Separator---
3.6.1
 2:
(1) Recovery key
1
(2) Power supply port (15 V DC)
(3) Status LED
(4) OBD connection cable port
(5) Network port (LAN 10/100 Mbit)
(6) USB 2.0 A port (1x)
(7) WLAN USB adapter (WLAN 802.11 b/g/n)
(8) USB 2.0 B port (1x)
---
3.6.2
The network port serves to provide a stable internet
connection in locations where a WLAN connection can‐
not be reliably maintained due to interference.
---Separator---
3.6.3
The storage battery is permanently integrated into the
housing and cannot be changed from the outside.
The fully charged storage battery of the KTS 250 is de‐
signed to guarantee approx. 2 hours of independent
operation.
The KTS 250 can be operated with the following volt‐
age supply:
• Storage battery
• Power supply unit
• OBD connection cable
---Separator---
3.6.4
The KTS 250 runs a closed operating system developed
on the basis of AOSP (Android Open Source Project). It
is not possible to install third-party software or apps
(e.g. from the Google Play Store).
---Separator---
Functional description
Interfaces
DIAG
1 2 3 4 5
View of KTS 250 interfaces
Network port
The network port can be used during initial com‐
missioning and for software updates.
Storage battery
With the OBD connection cable plugged in, the
KTS 250 is supplied with power by the vehicle
and recharged.
Charge the storage battery for at least 2 hours
before using the KTS 250 in battery mode.
Operating system
A A B
6 7 8
Robert Bosch GmbH