Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
EXHAUSTING HOT AIR
In the Cool Mode the appliance must be placed close to a window or opening so that the warm exhaust
air can be ducted outside.
GB
First position unit on a flat floor and make sure there's a minimum of 18"(45cm) clearance around the
unit,and is within the vicinity of a single circuit outlet power source.
1 .Extend either side of the hose (Fig.1)and screw
the hose inlet (Fig.2).
2 .Extend the other side of the hose and screw it to the hose outlet (Fig.3).
3 .Install the hose inlet into the unit (Fig.4).
4 .Affix the hose outlet into the window slider kit and seal. (Fig.5 &6).
Your window slider kit has been designed to fit most standard vertical and horizontal window applica-
tions,however, it may be necessary for you to modify some aspects of the installation procedures for
certain types of windows. The window slider kit can be fastened with screws.
NOTE: If the window opening is less than the minimum length of the window slider kit, cut the end
without the hold in it short enough to fit in the window opening. Never cut out the hole in window slider
kit.
131
Publicidad
