Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
OPERATION (CONT.)
– The installation of this heater must meet all
local codes and/or gas utility requirements. In
the absence of local codes, the National Fuel
Code ANSI Z223.1 should be followed.
– The minimum clearances to any combustible
construction materials must be maintained at
all times (See Page 3).
– Inspect the heater before each use, and at
least annually by a qualified service person.
!
WARNING: EXTREMELY HOT during
operation. Do Not touch any metal
components while in operation. Keep
gasoline and any other flammable liquids
away from the heater.
The Heat Hog Portable Propane Heater may
not burn as bright when operating at altitudes
over 2,000 FT. above sea level. This is normal.
At these high altitudes, the unit may shut off
sporadically due to lower levels of oxygen. If this
happens, provide fresh air and wait 5 minutes
and re-light. Localized atmospheric conditions
may cause heater to not re-light.
– In general, operating time will vary depending
on the heater setting and the supply cylinder
size. Up to 3 to 6 hours on a 1 lb. cylinder. Up
to 48 to 110 hours on a 20 lb. cylinder (based
on "HI" and "LO" settings). Run times of LP gas
can be significantly reduced when operating
continuously at temperatures below 20ºF. The
Heat Hog is designed to keep your 1lb cylinder
warm. When using a 20 lb. tank, you may
notice a decrease in BTU output.
– Your Heat Hog Portable Propane Heater is
equipped with a tip-over safety switch. When
moving the heater when lit, bumping heater,
setting it down or adjusting the heating angle,
the tip over switch may shut off heater. If this
happens, be sure the base is level and re-light.
– Condensation may build up on 1lb LP cylinder
and drip under heater. This may cause frost
on the bottom of the cylinder or may refreeze
under or around the heater. This is due to the
natural operation of small LP cylinders and is
normal.
– If heater shuts off, do not relight until you
provide fresh air. If heater keeps shutting off,
have the heater serviced. Keep burner and
control compartment clean.
Lighting & Operating Instructions for Use with
Disposable 1 Lb. Propane Cylinder
!
WARNING: Always inspect propane
cylinder and heater propane connections
for damage, dirt, and debris before
attaching propane cylinder. Do not use if
head of cylinder is damaged, punctured or
deteriorated.
ALWAYS ATTACH OR DETACH CYLINDER
OUTDOORS AWAY FROM FLAMES, OTHER
SOURCES OF IGNITION, AND ONLY WHEN
HEATER IS COOL TO TOUCH.
– Use only LP-gas cylinders marked in
accordance with the U.S. Department of
Transportation (DOT) or CSA B339, as
applicable. Cylinders must be provided with a
listed overfill protection device.
– Use only 1-lb. disposable cylinders (16.4 oz.)
that mate with No. 600 valve connection,
marked propane.
– Keep heater and cylinder in an upright position
during operation.
– Before attaching propane make sure Control
Knob on heater is in "OFF" position; see Figure
2.
– Tilt the regulator outward from the back and
screw the 1-lb. disposable LP-gas cylinder
clockwise (from bottom) into unit until hand-
tight; see Figure 3. DO NOT use thread sealant
on this connection.
– Be sure to inspect all connections for leaks,
by using a 50/50 mixture of dish soap and
water on all connection. Any bubbles forming
indicate a leak.
– Heater must not be exposed to flammable
vapors or liquids during lighting.
8
Publicidad
