Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION (CONT.)
DANGER: PROPANE IS AN EXPLOSIVE
!
GAS. WHAT TO DO IF THE SMELL OF GAS
IS PRESENT:
– DO NOT attempt to light the heater.
– Extinguish any open flame.
– Disconnect fuel supply.
– If odor continues, contact your local gas
supplier or fire department.
– DO NOT touch or use any electric switch
or any electric device that can cause a
spark.
– Immediately call your gas supplier from
a neighbor's phone. Follow the gas
suppliers instructions.
– If you can not reach your gas supplier, call
the fire department.
– Service must be done by a qualified
service agency.
WARNING: RISK OF BURNS, FIRE, AND
!
EXPLOSION!
– NEVER store or use gasoline or other
flammable vapors and liquids in the
vicinity of this heater.
– Young children should be carefully
supervised when they are in the are of
the heater.
– Clothing or other flammable materials
should not be hung from the heater or
placed on or near the heater.
– Any guard or other protective device
removed for servicing the heater must be
replaced prior to operating the heater.
– NEVER connect heater to an unregulated
gas supply.
– NEVER modify this heater or operate a
heater that has been modified.
– NEVER service, move or handle heater
while still hot or operating
Keep all combustible materials, gasoline,
and other flammable vapors and liquid away
from this heater.
Minimum Clearance from Combustibles
MODEL #
FRONT
HH-09SLN-A
40 in.
HH-18SLN-A
40 in.
CAUTION: HOT WHILE IN OPERATION. DO
!
NOT TOUCH. KEEP CHILDREN, ANIMALS,
CLOTHING, AND COMBUSTIBLES
AWAY FROM HEATER. HIGH SURFACE
SIDES
TOP
REAR
16 in.
40 in.
0 in.
16 in.
40 in.
0 in.
TEMPERATURES CAN CAUSE BURNS AND
CLOTHING IGNITION
WARNING: For use with propane (LP) gas
!
only.
– ALWAYS position the heater so that it is
not directly exposed to water spray, rain,
dripping water, or wind.
– Use heater in accordance with all local
codes.
– This heater is shipped from the factory
for use with propane (LP) gas only. Do
not convert to any other gas. Installation
must conform to local codes, or in
their absence, with the standard for
the Storage and Handling of Liquefied
Petroleum Gases ANSI/NFPA 58 and
the Natural Gas and Propane Installation
Code CSA B149.1.
– Gas supply connections should be
checked by using a 50/50 soap and
water solution. Never use a flame to
check for gas leaks.
– Use only the regulator and hose
assembly purchased from Heat Hog.
Inspect the regulator/hose assembly
prior to each use of the heater. If there
is excessive abrasion or wear, or if the
hose is cut, replace it with the proper
assembly prior to using the heater. The
replacement hose assembly should follow
manufacturer's specification.
– This heater is not for use on finished
surfaces such as floors and tables.
– Never use in a moving vehicle.
– Do not use for cooking or reheating food.
WARNING: The hose assembly shall be
!
protected from traffic, building material,
and contact with hot surfaces both during
use and while in storage. An enclosure for
a propane gas cylinder shall be ventilated
by openings at both the upper and lower
levels of the enclosure. The effectiveness
of the opening(s) for purposes of ventilation
shall be:
– One side of the enclosure shall be
completely open; or
– For an enclosure having four sides, a top
and a bottom:
– At least two ventilation openings shall
be provided in the sidewalls of the
enclosure, located at the valve level,
equally sized, spaced at a minimum of
90 degrees (1.57 rad), and unobstructed.
The opening(s) shall have a total free area
3
ENGLISH
Publicidad
