Use to bleach white and colorfast acrylics, cotton,
nylon, polyester and rayon (test to be sure). Do not
use on acetate, leather, silk, spandex or wool, mohair
and non-fast colors. Sort laundry by color and fabric.
Separate whites from colors and light colors from dark
colors.
Bleach Test – Before using, mix 1½ tablespoons of
bleach with 1/4 cup of water in a glass, rubber, glazed
porcelain or plastic container and test a small piece
of fabric in a place that doesn't show. Test all colors,
including trim. Let stand one minute, then blot dry. No
color change means the article can be bleached
safely.
Top Loading Machine – Before adding clothes, mix
3/4 cup of bleach with water in top-loading 16 gallon
machines. For large top loading automatics or larger
heavily soiled loads, use 1¼ cup. Add clothes.
Front Loading or High Efficiency Machine – Mix
1/3 cup bleach with water in front loading or HE 8 gallon
machines. If clothes are in machine, the addition of
bleach can cause damage.
*For HE washers, add using the bleach dispenser
following the machine manufacturer's instructions.
HOUSEHOLD LAUNDRY SANITIZERS
In Soaking Suds – Thoroughly mix 4.5 fl. oz. of this
product to 10 gallons of wash water to provide 200 ppm
available chlorine. Wait five minutes, then add soap or
detergent. Immerse laundry for at least 11 minutes prior
to starting the wash/rinse cycle.
In Washing Suds – Thoroughly mix 4.5 fl.oz. of this
product with 10 gallons of wash water containing
clothes to provide 200 ppm available chlorine. Wait
five minutes, then add soap or detergent and start the
wash/rinse cycle.
PAGE 8 OF 30
LAUNDRY
Top Load Automatic − 3/4 cup
Large Top Loading Automatic − 1¼ cup
Front Load Automatic − 1/3 cup
Large/Heavy Soiled Loads − 1¼ cup
To whiten nylon and other synthetics that have turned
yellow or gray: mix one tablespoon of this product per
gallon of water. Soak clean fabric in solution for 15 to
20 minutes. Rinse well. Repeat if necessary.
Machine Washing Directions: Use at least once per
month to keep your washing machine smelling fresh
and clean. If your HE machine has a cleaning cycle,
check the manufacturer's directions before use.
1.
2. Fill the bleach dispenser to the maximum level.
3. Run the cycle until it is completed.
4. Run a rinse cycle manually to flush out any
LAUNDRY SANITIZATION
COMMERCIAL LAUNDRY SANITIZERS
Wet fabrics or clothes should be spun dry prior to
sanitization. Thoroughly mix 4.5 fl. oz. of this product with
10 gallons of water to yield 200 ppm available chlorine.
Promptly after mixing the sanitizer, add the solution
into the prewash prior to washing fabrics/clothes in the
regular wash cycle with a good detergent. Test the level
of available chlorine if solution has been allowed to
stand. Add more of this product if the available chlorine
level has dropped below 200 ppm.
Select the hot water setting.
remaining bleach.
0323 RS-19457