Resvent iBreeze CPAP System Manual Del Usuario página 12


Do not place the device in or on any container that can collect or hold water.

Do not contact the metal surface of the heater when pull out the water tank.
7.2 Supplying AC Power
Complete the following steps to operate the device using AC power:
1. Plug the socket end of the AC power cord (included) into the power supply (also
included).
2. Plug the pronged end of the AC power cord into an electrical outlet that is not
controlled by a wall switch.
3. Plug the power supply cord's connector into the power inlet on the side of the device.
4. Verify that the plug at the side of the device, at the power supply, and at the electrical
outlet are fully inserted.
5. When turn off the device Press Therapy On/Off Button and the device will stop work.
6. Disconnecting Network power source.
WARNING:
 During use if the power cord is disconnected or a power failure, the device buzzer
alarm beeps. Please stop using it and check the power status.
 Please do not contact with the DC in connector when it was broken.
 Please avoid arcing, wiggling, or dropping the power supply on hard surfaces.
 Please periodically inspect electrical cords and cables for damage or signs of wear
and to discontinue use and replace if damaged.
iBreeze CPAP System User Manual
9