Publicidad
Idiomas disponibles
Idiomas disponibles
MN008300A01-AB
Chapter 5 : Charging Procedure
Chapter 5
Charging Procedure
Batteries charge best at room temperature. IMPRES 2 Multi-Unit Chargers can charge a stand-alone
battery or a battery attached to a radio.
When and where to use:
Figure 2: Charging Radio
Procedure:
1 Place the Multi-Unit Charger (MUC) on a flat surface.
2 Firmly insert the power supply into the charger DC Inlet Socket at the back of the charger.
3 Plug the power supply power cord into a matching power outlet.
Upon successful power-up, each pocket LED shows green for one second and displays IMPRES
2 CHARGER. If the LEDs do not flash and no message is displayed, check power cord
connections.
4 Insert the radio with battery or stand-alone battery into an available pocket.
The followings are the indication when the radio or stand-alone battery is properly seated in the
pocket:
•
Charging status of a radio is indicated by the LED status indicator or display of the radio.
•
The display of the MUC shows the charging status of Pocket 1 only.
The radio or stand-alone battery is ready for use when the LED is steady green.
NOTE:
To ensure optimized charging performance, turn off the radio while charging unless the
radio is transmitting data wirelessly on Wi-Fi or Bluetooth.
Grip the radio body when inserting, or removing the radio from the charger. Avoid pulling
the radio antenna when removing the radio.
20
Publicidad
