3 Lift the charging pocket a few inches away from the base.
4 Remove the pocket harness by pulling straight up on the connector.
11.2
Securing Charging Pocket to Multi-Unit Charger
Figure 21: Securing AS000700A01 Charging Pockets to Multi-Unit Charger Base
1
Item
Description
1
AS000700A01
2
Harness Receptacle
Procedure:
1 Plug in the USB connector and harness connector to the receptacles on the base.
NOTE: The USB or harness connector may not be available on some of the charger
pocket. Plug in the available connectors to the base.
2 Slot in the charging pocket to the base and ensure the charging pocket is flushed into the
Multi-Unit Charger. Affix the charging pocket screw.
MN008300A01-AB
Chapter 11 : Charging Pocket Installation
2
49