Publicidad
Idiomas disponibles
Idiomas disponibles
MN008300A01-AB
Chapter 12 : Optional Equipment
Chapter 12
Optional Equipment
Wall mount brackets are available for the Multi-Unit Charger (MUC).
Table 18: Recommended Bracket for each Multi-Unit Charger Kit
Bracket, Part Number
BR000272A01
WARNING:
•
This wall mount bracket should be installed by a trained and experienced technician. Having
the product installed by a non-specialized technician is very dangerous, and can cause
damage or injury.
•
Do not install the product where the weight cannot be supported. If the strength of the
location where the wall mount is installed is not strong enough, it can fall off and cause an
injury.
•
Do not install on a structure that is prone to vibration, movement, or chance of impact.
12.1
Mounting Multi-Unit Charger to Wall Bracket
Procedure:
1 Position the wall mount bracket in the desired position, and mark the location of the mounting
holes on the wall surface.
CAUTION: Ensure the area behind the mounting surface is always free of electrical
wires, cables, and pipes before cutting, drilling, or installing the mounting screws.
NOTE: Mount bracket to the wall using the appropriate mounting hardware required for
the type of wall material fixture.
2 Drill based on the marked mounting holes on the wall surfaces.
3 Secure the wall bracket in position by installing mounting hardware over the mounting holes on
the wall bracket tightly.
NOTE: It is recommended to use 10-16 X 1-1/2" tapping screw and washer (not
included) on wood stud and solid flat concrete or brick wall.
4 Hang the multi-unit charger to the designated wall bracket as shown in the following images.
Table 19: Mounting Multi-Unit Charger (MUC) to Wall Bracket
1. Mount the BR000272A01 bracket onto the
wall.
50
Multi-Unit Charger, Kit Number
PMPN4593_
2. Install the power adapter.
Publicidad
