Descargar Imprimir esta página

Wayscral TAKEAWAY E100 Manual De Instrucciones página 58

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 90
After recharging for more than 4/5
hours, the charge indication LED is still
red
(note: it is very important to recharge
the
battery
according
instructions to avoid damaging the
equipment).
Solving charger-related issues:
Red light does not work when charging: check that the connectors are properly connected.
Check if the normal voltage went right away, if so, please check the charger repair. If the above
is correct, the battery is likely faulty.
The red light does not turn green: turn off the power, after 5 seconds connect the mains supply,
it can continue to charge. The battery no longer charges, the battery is likely faulty.
The red light turns immediately green: check that the battery is fully charged. If it is not, the
battery or charger is faulty.
If the fuse has blown: do not disassemble the charger, but take it to a qualified repairer who will
replace the fuse with a new one with the same characteristics (T3.15A/250V).
1) the ambient temperature is 40°C
or higher
2) the ambient temperature is 0 ° C or
less
to
the
3) The bicycle was not recharged
after use which exacerbated the
decrease in charge
4) The output voltage is too low to
recharge the battery.
58
1) recharge the battery at a
temperature below 40°C and in
accordance with the instructions
2) recharge the battery indoors and in
accordance with the instructions
3) correctly maintain the battery to
avoid an exacerbating the decrease in
charge
4) Do not recharge with a voltage
lower than 100 V.
If the previous solutions don't work
contact your dealer or a qualified
professional.

Publicidad

loading