Publicidad
Idiomas disponibles
Idiomas disponibles
HIGH PRESSURE DETERGENT: (CLEANING WITH DETERGENTS)
NOTE: This feature is designed for use with mild detergents only. Since the cleaning solution travels through
various parts of the pressure washer, do not use corrosives as they will cause extensive damage as well as
pose a considerable safety hazard.
1. Refer to "Risk of Bodily Injury / Detergents". Be certain to wear protective safety attire as stated.
2. Prepare detergent solution according to label directions.
fluids or solvents through the unit. Due to the unknown and often corrosive characteristics of many
detergents commonly used in the pressure washer cleaning industry, it is recommended to use only
mild detergents with this unit.)
DETERGENT METERING VALVE
3. With the trigger gun locked in the "OFF" position, securely quick-connect the detergent spray nozzle (#6540° BLACK)
into the end of the wand.
NOTE: This injection system is designed to apply detergents under low pressure only. It will not allow detergent
solutions to be introduced into the system unless the nozzle assembly is in the low pressure detergent mode.
4. Fully immerse the strainer end of the clear vinyl detergent hose into the detergent solution.
5. To apply solution; unlock the trigger gun and squeeze the trigger. In a few moments a detergent/water mixture will
exit the nozzle. Start spraying the lower portion of the surface being cleaned and move up, using long overlapping
strokes. Applying from the bottom up helps avoid streaking. Allow to soak briefly. Avoid working on hot surfaces
or in direct sunlight to minimize the chances of the detergent drying, which may result in damaging surfaces. Be
certain to apply cleaning solution to a small section at a time.
6. To rinse; lock the trigger gun in the "OFF" position. Turn the detergent metering valve to the "OFF" position. Unlock
the trigger gun and spray. It will take about 30 seconds to purge all detergent from the line. For best rinsing results,
start at the top and work down.
7. Siphon a gallon of water through the detergent injection system after each use. This prevents the possibility of
corrosion or detergent residue causing mechanical problems during the next use.
22
OPERATING INSTRUCTIONS
(Never pump acids, alkalines, abrasive
HMT-4004-0MGH Operator's Manual
Publicidad
