Connecting The Pc; Closing The Casing - Auerswald COMpact 5200 Manual De Instrucciones

Commissioning (COMpact 5200)
Important: Before you insert a COMpact 2BRI module, first make the necessary port set-
tings on the module (operating modes and terminators).
The slot on the far left (A) is exclusively reserved for the COMpact CPU module included in
the scope of supply. The slot on the far right (4) is reserved for future extensions.
Inserting a Module:
1. Slide the module into the board guides with
the component side pointing to the left. Also
pay attention to the board guide on the cover.
2. Press the module upward until the board lock
clicks into place.
Removing a Module:
1. Unlatch the board lock, for example with your
right thumb.
2. Remove the module with your other hand.

Connecting the PC

Requirements:
• Available network socket on the PC or in the
network of the PC
1. Insert one end of the accompanying network
cable into the network socket on the PC or in
the network of the PC.
2. Insert the other end of the network cable into
the RJ-45 socket of the CPU module.

Closing the Casing

Note: The connections for the first commissioning (connection to a PC/network and, if nec-
essary, connection of a few terminals) must be made before the casing is closed. Alterna-
tively, you can prepare them by laying a connecting cable that leads out of the housing.
44
COMpact 5200/5200R/5500R - Instructions V01 03/2017