Closing The Casing; Connecting The Pc; Turning On The Pbx - Auerswald COMpact 5200 Manual De Instrucciones

Closing the Casing

Requirements:
• Screw driver (Phillips)
1. Remove the dummy panels at those points where modules
have been inserted by pressing them outward from the in-
side, for example with your thumb.
Note: Dummy panels that have been removed can be reinserted
any time. For a COMpact 2FXO module with only two RJ-45 sock-
ets you can break a dummy panel into halves at intended break-
point at the centre and reinsert one of the halves.
2. Place the front panel onto the casing.
3. Secure the front panel with its four screws.

Connecting the PC

Requirements:
• Available network socket on the PC or in the network of the PC
1. Insert one end of the accompanying network cable into the network
socket on the PC or in the network of the PC.
2. Insert the other end of the network cable into the RJ-45 socket of the
CPU module.

Turning on the PBX

Warning: Touching voltage-carrying conductors or telephone connections can cause
life-threatening electric shocks.
• Close the casing before you put the PBX into operation.
Note: If you have a USB memory stick with a configuration for automatic loading (aucon-
fig.cfg), insert it into the USB socket (USB host) of the CPU module before you switch on the
PBX. The configuration data stored on the USB memory stick will automatically be saved to
the PBX after switching on. The PBX restarts afterwards.
Requirements:
• PBX connected to earthing and casing closed
COMpact 5200/5200R/5500R - Instructions V01 03/2017
Commissioning (COMpact 5200R/5500R)
49