RIB SLIDER 2.0 Manual página 38

5
Central electric lock installation (ACG9462B)
The "central" locking device mechanically locks the doors in closed posi-
tion. The control unit can manage the electric lock in "locking on each door
closure" or "locking in night stop" mode.
5.1 - Fasten the two brackets to the carriages using the 4 screws A
\
5.2 - In the specific strokes, insert the 4 hex head screws B as in the figu-
re. Then, fasten the electric locking unit using the 4 nuts C.
Pay attention to the correct alignment of the electric lock pin with the
holes in the brackets.
B
C
5.3 - Pass the lever unlocking cord as indicated in the figure, then fasten it
on the end with the specific stop.
Fasten the manual unlocking lever in the desired position using the hole F.
Adjust the tightening of the steel cable C with the lever L in the
A
"unlocked" position and bracket S turned completely SX.
For further adjustments, use the adjustment screws R.
IMPORTANT: Set the TYLK parameter of the ADV menu on LK1
Apply a table that indicates the near to the release lever
manual door release mode.
R
5.4 - Connect the electric lock output to the LK terminals of the com-
mand control unit.
6
F
L
S
-
+
LK
F
R
V