Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the SENSOMASTER software
Installing the
SENSOMASTER software
The SENSOMASTER software can be used, for
example, to create bolting operations and sequence
plans on the PC. These data can then be
transferred to the MANOSKOP's internal memory
and called up there. The MANOSKOP menu may
also be individually configured.
The following system prerequisites are required for
installation:
Standard PC (Netbook or higher)
Microsoft Windows
7 operating system (32- or
®
64-bit) or
Microsoft Windows
Vista operating system (32-
®
or 64-bit)
A free USB port
The SENSOMASTER software can be found on the
enclosed data medium. Proceed as follows to install
the SENSOMASTER software (administrator rights
required):
Use the enclosed data medium for installation.
If the installation dialogue does not start
automatically, open the Windows Explorer and
double-click onto the Sensomaster.exe file.
Select the desired language for installation.
Click onto "Cancel" to cancel installation.
Click onto "OK" to confirm the language selection
and continue installation.
The SENSOMASTER set-up wizard starts.
Click onto "Cancel" to cancel installation.
To continue installation, click onto "Continue".
The licence agreement must be accepted to
continue installation.
Click onto the corresponding option field.
To change settings which have been undertaken,
click onto "Back".
Click onto "Cancel" to cancel installation.
To continue installation, click onto "Continue".
21
Publicidad
