Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing the torque and angle wrench
Plug-in tool installed rotated by 180°
Insert a thin drift into the detent hole on the upper
side of the wrench head from the outside.
Use the drift to depress the retaining pin (A).
Pull the plug-in tool out (B).
Determining the extension length
WARNING
Danger of severe injuries due to an
incorrect extension length.
Check the extension length in the
case of each plug-in tool.
Set the appropriate extension length
for plug-in tools.
Use a caliper gauge to determine the extension
length S as shown in the drawing. If combinations of
plug-in tools and adapter cards are used, the sum
of all "S" values must be taken into consideration.
Further information can be found in the
STAHLWILLE catalogue.
17.5
If an extension length which does not
correspond to the standard extension length is
input, the
symbol is shown on the display.
26
mm.
Input the corresponding extension length when
the extension length is queried.
The torque and angle wrench automatically corrects
the torque according to the set extension length.
Switching the torque and angle wrench
on and off
To switch the torque and angle wrench on, press
any button for approx. one second.
A long audible signal is heard.
The menu language set on delivery is German.
To change the menu language, proceed as
described from page 41.
When the torque and angle wrench is not in
use, it switches off after a specified period of
time. The shut-off time can be defined using the
SENSOMASTER software, see page 42.
To switch the torque and angle wrench off, press
the HOME button for more than one second.
Three short audible signals are heard.
Taring the torque and angle wrench
To ensure precise measurement, the torque and
angle wrench must be tared in the case of each
bolting process.
WARNING
Risk of injury due to incorrect
measured values caused by improper
taring.
Make sure that the torque and angle
wrench is not moved or loaded
during the taring process.
The torque and angle wrench is automatically
tared each time when it is switched on.
Publicidad
