Stahlwille MANOSKOP 714 Manual De Instrucciones página 96

Menu overview
"Configuration & Data" menu
The "Configuration & Data" menu contains the following menu items:
 Configuration
 Data
 Messages
 Version Info.
Configuration menu item
Alert
Save on/off
Ser. Communication
Calibration Info
Max. Loads
Data menu item
Saved Fastener Data
Messages menu item
Existing Messages
36
The alert limit is defined by inputting a value. If the alert limit is
reached, the yellow signal lamps light up and the value is
shown in yellow on the display.
Whether bolting process data are to be saved or not is defined
here.
This menu item must be activated for calibration with a
STAHLWILLE perfectControl
facility.
So that the torque and angle wrench functions flawlessly
again, the torque and angle wrench must be switched off once
after calibration.
The next due calibration date is displayed here.
The torque and angle wrench cycles which have taken place
up to the current point in time are also displayed.
The maximum applied torques are displayed here.
The saved fastener data can be seen here.
Existing messages, e.g. that the calibration date has been
exceeded, can be seen here.
calibration and adjustment
®