Publicidad
Idiomas disponibles
Idiomas disponibles
Make sure that the STOP / RUN switch is in the RUN position (Pic.6)(6.1 ).
Hold down the hole borer firmly with one hand. With the other hand grip the recoil starter cord
handle (Pic. 7) and pull slowly until resistance is felt indicating that the recoil starter is engaged.
When resistance is felt pull the cord sharply. Continue this procedure until the engine starts.
When the engine has been successfully started and is running smoothly return the choke lever to
the OFF position.
Press in the safety switch lever (Pic.6)(6.2) then squeeze the throttle lever (Pic.6)(6.3), the auger
bit will begin to rotate. To adjust the boring speed rotate the speed adjuster (Pic.6)(6.4) until the
desired setting is achieved.
To stop the auger bit from rotating, briefly squeeze then release the throttle lever.
OPERATING THE HOLE BORER
- This product requires the use of two hands to ensure safe operation.
- Make sure that the hole boring operation does not involve the risk of contact with electric
cables, gas mains. water pipes etc.
- Inspect the work area before starting. Remove any objects or debris that could be thrown,
jammed or become entangled in the auger bit.
- Adopt a stable stance always keeping the hole borer in front of your body. Grip the handles
with both hands ensuring you can safely operate the oontrol levers.
- Allow the auger bit to reach full speed before oommencing the boring operation.
39
Publicidad
