Dreame DreameBot D9 Plus Manual Del Usuario página 9

Routine Maintenance
EN
Clean the Dust Bin
* Clean after each use
1. Open the robot cover, then press the dust 2. Open the bin cover and empty the
bin clip to remove the dust bin. bin as shown in the diagram.
Clean the Filter
2. Do not wash the filter. Only the dust bin is washable. Thoroughly dry it before re-installing.
1. Remove the filter and tap its basket gently.
Note:
· Do not attempt to clean the filter with brushes or fingers.
· Rinse the dust bin with clean water only. Do not use any detergent.
· Use the dust bin and filter when they are completely dry.
· The filter is recommended to be cleaned every two weeks and replaced every three months.
12
3. Clean the dust intake.
12
11 1
10 2
24 hrs
9 3
8 4
7 5
6
Routine Maintenance
Clean the Mopping Module
1. Press the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean with only water and leave out to air
dry before re-installing.
Note: Do not expose the tank to the sun directly.
3. Clean the mop pad with water only and leave to air dry before re-installing.
12
11 1
10 2
24 hrs
9 3
8 4
7 5
6
Note:
• Remove the pad from the mopping module before cleaning it, and make sure
dirty water does not flow back into the water outlet to avoid clogging.
• For optimal performance, it is recommended to replace the mop pad every 3-6
months.
4. If slow water flow occurs, or the volume is not well-distributed, clean the air
hole in the cover of the water tank.
EN
13