Steering Guide Installation - HONDA marine BF40D Instrucciones Del Montaje

STEERING GUIDE INSTALLATION

Push-Pull Type
• Attach the steering guide cable to the outboard motor first, then install the outboard motor on the boat.
• Refer to the steering guide cable manufacturer's manual for cable handling procedures.
CAP NUT
(Marine grease)
Install the cap nut by
removing the cap.
CAP
Not necessary when the
guide cable is installed.
3/8-24 UNF NUT
STEERING
ROD COLLAR
(Marine grease)
3/8-24 UNF BOLT
CAP ASSEMBLY
(Marine grease)
3/8-24 UNF SELF-LOCKING NUT
18 N . m (1.8 kgf . m, 13 lbf . ft)
3/8-24 SELF UNF LOCKING NUT
18 N . m (1.8 kgf . m, 13 lbf . ft)
TILTING SHAFT
27
STEERING LINK PLATE
STEERING ROD
10 mm WASHER (3)
STEERING GUIDE CABLE
(Marine grease)