Control Cable Installation - HONDA marine BF40D Instrucciones Del Montaje

CONTROL CABLE INSTALLATION

Control Box Side
HOUSING COVER C
6 mm LOCK PIN (2)
WASHER (2)
EYE END (2)
LOCK NUT (2)
1) Remove the two 5 x 25 mm self-tapping screws
and housing cover C.
2) Screw the lock nuts and eye ends more than
8 mm (0.3 in) onto the thread of the control
cables and tighten the lock nuts securely to hold
the pivots. Apply marine grease to the hole of the
eye end.
5 x 25 mm SELF-TAPPING
SCREW (2)
THROTTLE CONTROL CABLE
LOCK NUT
EYE END
31
CABLE CLAMP SPACER
SHIFT CONTROL CABLE
More than 8 mm (0.3 in)
(Marine grease)