Beem CM5418C-GS Manual De Instrucciones página 27

27
Before Initial Use
1. Wipe the device with a clean, damp cloth. Clean all accessories with a little detergent and
clear water.
2. When the device is delivered, the water tank (15) is fitted with transport protection that
needs to be removed. Pull it vertically up out of the device. A plug is secured on the bot-
tom of the water tank – pull it out. The water tank can now be filled and inserted into the
device.
3. Set up the device and connect it (see the "Setting Up and Connecting the Device" chapter).
4. Before you enjoy your first espresso or coffee, we recommend that you carry out a trial run
to remove any possible production residues in the device and the water system. To do this,
follow the instructions in the "Operation and Functions" and "Preparation" chapters.
When the device is first used, production­related additives may cause a small amount of
smoke and / or an odour to be produced. This is normal and not a device defect.
5. Repeat this process twice. Do not drink this espresso!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).
Setting Up and Connecting the Device
PLEASE NOTE!
• Only connect the device to a plug socket that is properly installed. The plug socket
must also be readily accessible after connection so that the connection to the mains can
quickly be isolated. The mains voltage must match the technical data of the device.
• Lay the connecting cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
• Do not use the device in conjunction with extension cables.
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a flat, solid and heat­resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
1. Place the device on the kitchen unit or another dry, clean work surface, following the safety
notices and the notices provided at the beginning of this chapter.
2. Plug the mains plug into a plug socket. You will hear a beep and all control lamps light up
briefly. The device is in standby mode.
EN