Beem CM5418C-GS Manual De Instrucciones página 32

EN
Preparation
PLEASE NOTE!
• Do not operate the device without water or with less water than is required to reach
the MIN marking.
• Never use the device without a suitable cup below the portafilter.
Making Espresso
1. Fill the water tank (15) (see the "Preparation" chapter – "Filling the Water Tank").
2. Make sure that the steam power control (4) is in the OFF position.
3. Switch on the device by pressing the
mode. The control lamp
(19) flash.
Once the preheating has ended, all control lamps are constantly lit. The device is ready to
operate.
4. Prepare the portafilter (9) for the espresso you want in the manner described in the
"Preparation" chapter and insert it into the device.
5. Place one or two suitable cup(s) on the storage plate (11) under the portafilter.
With two cups make sure that they are each positioned next to each other below an
outlet under the portafilter.
6. Press the button
process. The corresponding control lamp flashes. The set quantity of water runs through
the portafilter into the cup(s). The device then automatically switches to standby mode.
All control lamps light up again constantly.
7. Switch off the device by pressing the
If there is no more action, the device automatically switches off after approx. 30 minutes.
button (16). The device switches to preheating
is lit constantly and the control lamps
(Single espresso) or
button. All control lamps go out.
(Double espresso) to start the brewing
32
(17), (18) and