Puky KINDER-STRASSENFAHRRAD Manual De Instrucciones página 18

ASSEMBLY HANDLEBAR WITH STEM
You will need the following tools for assembly
(not part of the scope of delivery)
• 6mm hex key
• 13 mm spanner
1. Insert the handlebar into the steer tube. If this
proves to be difficult, unscrew the handlebar a bit
further. Adjust the handlebar to the desired height,
align at right angles to the front wheel and lock it.
SETTING AHEAD STEM
The handlebar has been set at the factory to the highest position, thus, all spacers are located under the
stem. If required, remove the stem and adjust the spacers to lower the handlebar height.
For adjusting the handlebar height for models with ahead stem you will need the following tools.
(The tools are not part of the scope of delivery.)
• 5 mm and 4 mm Hex key
1
1. First undo and remove the ahead cap
(5mm Allen key).
2. Then undo the two steerer tube clamping screws
(4mm Allen key ).
3. Now the stem can be removed from the steerer
18
1
2. By pulling the screw at the stem with the aid of a
6 mm Allen key (YOUKE models) or a 13 mm span-
ner (STEEL/ STEEL CLASSIC models) (15 Nm).
2
tube. Now set the handlebar height according to
requirement. Possible positions are:
• All spacers located under the stem
(highest handlebar position, set at the factory)
2
15 Nm
Please pay attention to the marking of the minimum
insertion depth of the stem shaft. Now reattach the
handlebar padding back onto the handlebar.
2
3
• Spacers over the stem and under
(medium handlebar position)
• All spacers above the stem
(lowest handlebar position)
No spacers may be removed!
GB