Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING THE BRAKE PADS
For replacing the brake pads you will need the
following tools.
(The tools are not part of the scope of delivery.)
• 5 mm Hex key
1
1. Undo the fastening nut of the brake pad using an
Allen key sized 5 mm (1) and replace the brake pads.
SETTING THE CHAIN TENSION
(MODELS WITH GEAR HUB)
For setting the chain tension you will need the following tools.
(The tools are not part of the scope of delivery.)
The counterholder of the coaster hub must also be loosened, otherwise the rear
wheel cannot be moved.
• 15 mm spanner
1
GB
2. This means that the brake pads should rest 1 mm
below the top edge of the rim . If these settings are
not correct, loosen the fastening nut of the brake pad
with a 5 mm Allen key and align as described above.
To do so, pull the brake lever and re-tighten the
3. The tension is to be set so that the brake pads are
The chain should have a vertical play of approximate-
ly 1.5 cm. The setting of the chain tension is carried
out as follows:
1. Undo both wheel nuts of the rear wheel.
2. Adjust the chain tension by sliding the rear wheel
2
fastening nut (5-8 Nm).
all approximately 1.5 mm from the rims. If subse-
quent adjustment is necessary, undo the tensioning
screw and adjust the tension (tighten the tensioning
screw back up using 6-8 Nm!) or carry out the step
described in brake lever and tension step 2.
2
at the dropout. Then tighten the wheel nuts again
(torque 15 Nm)
Tire change at www.puky.de
5-8Nm
3
!
21
Publicidad
