The Machine Does Not Remain In Neutral; Transporting The Machine - Grillo CL62 Manual De Instrucciones

– Speed too high for cutting height
– Cutting deck not parallel to ground
– Blades fault
– Blades unbalanced
– Fastenings are loose

THE MACHINE DOES NOT REMAIN IN NEUTRAL

Adjust the device (fig. 11, ref. A) by loosening the counter-nut and acting on the M8 screw.
ENDING WORK
Release the forward lever to stop the machine (fig. 1, no° 1). Put the throttle lever in the STOP position
(fig. 2, ref. A) to switch off the engine.
STORAGE AND PROLONGED PERIODS OF INACTIVITY
Store the mower in a dry place, away from atmospheric agents, and preferably cover it with a sheet.
Follow the instructions included in the engine manual. If the machine is to be out of use for more than 30
days, drain the fuel from the engine to prevent sticky deposits from occurring in the fuel intake system or
in vital parts of carburettor. To avoid this procedure, it is possible to save fuel in storage up to 12 months
by using an appropriate fuel stabilizer. Add this additive to the fuel in the tank or in the fuel container.
Run the engine for a while to let the stabilizer get into the fuel system. Caution: if the engine is fed with
petrol containing alcohol, drain the fuel tank and run the engine until there is no fuel left.

TRANSPORTING THE MACHINE

If the machine has to be transported on a lorry or a trailer, lower the mower deck, engage the parking
brake and fasten the machine to the vehicle using ropes or cables.
CL62/ Translation of the original instructions
Drop in engine performance during cutting
11
Uneven cutting
Vibrations during work
– Reduce speed
– Raise cutting height
– Check tyre pressure
– Check that the blades are correctly mounted
– Sharpen or change the blades
– Check the tension of the deck engine belt
– Balance blades or replace them if damaged
– Check and fasten the blade fixing screws as
well as the fixing screws of the engine and
chassis.
12