Publicidad
Idiomas disponibles
Idiomas disponibles
6 Putting into operation
6.3 Electrode welding
6.3.1 Connecting the electrode holder
Fig. 7
A Positive earth cable socket
B
Connect the electrode holder to the appropriate earth socket in line with the information on the welding
1
electrode's packaging. Leave the wire feed unit with control lead connected to the device.
Use an earth cable with a minimum cross-section of 50 mm
cross-section.
Connect the workpiece clamp to the workpiece with good conductivity.
2
Connect the earth cable to the earth socket and turn it clockwise to secure it in place.
3
6.4 TIG welding
6.4.1 Connecting the TIG welding torch cable assembly
Fig. 8
A Positive earth cable socket
B
Use an earth cable with a minimum cross-section of 50 mm
section.
Connect the workpiece clamp to the workpiece with good conductivity.
1
Connect the earth cable to the positive earth cable socket (A) and turn it clockwise to secure it in place.
2
Connect the TIG torch cable to the negative earth cable socket (B).
3
Connect the TIG burner's shielding gas hose to the shielding gas cylinder's decompression valve.
4
6.5 Establishing the power supply
► Note the safety instructions.
2.6 Safety instructions for the electrical power supply on page EN-10
Electric shock due to improperly installed electrical power supply
If the electrical power supply and ground connection are improperly installed, fatal electric shocks may
occur.
► If you want to operate the device in a very humid environment or on conductive material, install
► Use fast-acting circuit breakers.
► Protect the power supply line to the device with suitable fuses that comply with regulations.
► Ground the device according to the applicable regulations.
► Do not ground the device together with other devices and machines.
Electric shock due to defective cables
The use of damaged or improperly installed cables may result in a potentially fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Have any damaged, deformed, or worn parts replaced by a qualified electrician only.
EN - 20
Connecting the electrode holder
Connecting the TIG welding torch cable assembly
WARNING
a residual current circuit breaker in the power supply.
WARNING
B Negative earth cable socket
A
2
. If an extension is necessary, use a larger
B Negative earth cable socket
A
2
. If an extension is necessary, use a larger cross-
xFUME POWER 350
Publicidad
