Abicor Binzel xFUME POWER 350 Manual De Instrucciones Original página 87

xFUME POWER 350
13 Material table
13.1 Default programs
The following materials are programmed into the control system by default:
Tab. 13 Material table – default programs
Material
Steel
Steel
Steel
CrNi 4316 ER308
CrNi 4576
ALMG 5
ALSi 5
CuSi 3
Metal powder flux-cored
wire T424 MC2 H5
Alkaline flux-cored wire
T424 BC4 H5
Rutile flux-cored wire
T422 PC1 H5
13.2 Special programs
The following special programs (arcs) are available:
Tab. 14
Material table – special programs
Material
Steel
Steel
Steel
Tab. 15 Special program descriptions
Display Arc
CSt
Reduced-power cold arc
(cold steel)
PSt Concentrated, high-pressure spray arcs
(power steel)
rSt Spatter-reduced short arcs
(root steel)
Display Shielding gas
St Argon 82%, CO 18% – MIX 18
2
St Argon 90%, CO 5%, O
2
St CO
2
4316 Argon 98%, CO 2% – MIX 2
2
4576 Argon 98%, CO 2% – MIX 2
2
ALnG Argon 100% (Ar)
ALSi Argon 100% (Ar)
CuSi Argon 100% (Ar)
nEPU Argon 82%, CO 18% – MIX 18
2
bASI Argon 82%, CO 18% – MIX 18
2
ruti Argon 82%, CO 18% – MIX 18
2
Display Shielding gas
CSt Argon 82%, CO 18% – MIX 18
2
PSt Argon 82%, CO 18% – MIX 18
2
rST Argon 82%, CO 18% – MIX 18
2
Use
Root welds and sheet-metal welds,
including with MIG soldering.
Controllable, stable welding in the
upper power range.
Controllable, stable welding in the
upper power range.
Display Wire diameter
Ar82 0.8 mm–1.0 mm–1.2 mm–1.6 mm
5% Ar90 0.8 mm–1.0 mm–1.2 mm–1.6 mm
2
CO 0.8 mm–1.0 mm–1.2 mm–1.6 mm
2
Ar98 0.8 mm–1.0 mm–1.2 mm
Ar98 0.8 mm–1.0 mm–1.2 mm
Ar 1.0 mm–1.2 mm
Ar 1.0 mm–1.2 mm
Ar 0.8 mm–1.0 mm
Ar82 1.2 mm
Ar82 1.2 mm
Ar82 1.2 mm
Display Wire diameter in mm
Ar82 0.8 mm–1.0 mm–1.2 mm
Ar82 0.8 mm–1.0 mm–1.6 mm
Ar82 0.8 mm–1.0 mm–1.2 mm
Technical specifications
— excellent gap bridging
(including downward)
— low heat input zone
— low workpiece distortion
— excellent root and side fusion
— high welding speed
— low heat input
— excellent root and side fusion
— high welding speed
— low heat input
13 Material table
EN - 41