Yamaha 40V Manual Del Propietário página 68

TACH TACH
x100 x100
r/min r/min
TACH TACH
x100 x100
r/min r/min
TACH TACH
x100 x100
r/min r/min
TACH TACH
x100 x100
r/min r/min
NOTE:
After the main switch is first turned on all
segments of the display come on as a
5 5
check. The tachometer and trim meter will
4 4
indicate the maximum reading and the
3 3
oil-level indicator and overheat warning
2 2
indicator will light. After a few seconds,
1 1
the meters will change to normal opera-
tion. Watch the meter when turning on
802012
the main switch to make sure all seg-
ments come on.
EMU00136
5 5
Tachometer
4 4
This meter shows the engine speed.
3 3
2 2
EMU01109
Trim Meter
1 1
This meter shows the trim angle of your
802042
outboard motor.
NOTE:
8 Memorize the trim angles that work
best for your boat under different condi-
tions. Adjust the trim angle to the
5 5
desired setting by operating the power
4 4
trim and tilt switch.
3 3
8 If the trim angle of your motor exceeds
2 2
the trim operating range, the top seg-
1 1
ment on the trim meter display will start
to blink.
802015
EMU00138
Oil-Level Indicator
This indicator shows the engine oil level.
5 5
If the oil level falls below the lower limit,
4 4
the warning indicator will start to blink.
3 3
Refer to the sections "FILLING OIL" and
2 2
"OIL LEVEL WARNING" for details.
1 1
1 Oil-level indicator
q
802013
2-20
E