Vimar ELVOX RS08 Manual De Instrucciones Para La Conexión Y El Uso página 29

4.6- Sensitive edge connection
Programmable input: (when the edge or photocell is not engaged, the STPA LED must be on) the operation of this input, set as a sensitive edge, has this
effect: during opening it immediately reverses the movement for 1.5 seconds and then stops the gate, while during closing it reverses the movement until fully
open. See parameter number 06 (edge with normally closed contact set parameter 06 to value 2, edge with balancing resistance 8.2 K ohms set parameter
06 to value 3), if not used make a bridge between COM. and STPA and leave parameter 06 on value 1.
4.7- Connecting photocells with photo-test function active
If the photo-test function is activated (the control unit checks the operation of the photocells, see parameter 08), respect the following connection (each time
the motor starts the control unit cuts off power to the transmitter of the photocell to check their operation):
5 6 7 8 9 10 11 12
EN
Resistive sensitive edge connection
13 14 15 16 17 18 19
8,2 KW
13 14 15 16 17 18 19
STPA
internal photocell
COM
STPA
+
-
COM
FOTO
Switch edge connection
13 14 15 16 17 18 19
RX
+ - C NC NA
as
+
-
RX1
+ - C NC NA
TX
+ -
RX2 TX1
+ - C NC NA + -
Fig. 8
TX2
+ -
Fig. 9
27 27