Vimar ELVOX RS08 Manual De Instrucciones Para La Conexión Y El Uso página 36

7.4- PAR:
Used to modify all the parameters of the control unit, press the UP button until PAR appears on the display, confirm with the OK button to display
the list of parameters, the display will show P01 (parameter number 1), the UP or DOWN button lets you scroll through the list of parameters (see parameter
table)
x4
Parameter table
Parameter
number Description
P01 Enables automatic closing
P02 Sets the automatic closing time
P03 AP/CH input operation
P04 Pre-flash
P05 Closing after photocell disengagement
P06 Type of safety device connected to the
STPA input
P07 AUX output operating mode
P08 Enables photocell control
P09 Slowdown distance when closing M1
P10 Slowdown distance when closing M2
P11 Slowdown distance when opening M1
P12 Slowdown distance when opening M2
P13 Opening speed M1
P14 Opening speed M2
P15 Closing speed M1
P16 Closing speed M2
P17 Opening deceleration speed M1
P18 Opening deceleration speed M2
P19 Closing deceleration speed M1
P20 Closing deceleration speed M2
P21 Motor M1 force
P22 Motor M2 force
P23 Acceleration on starting M1
P24 Acceleration on starting M2
P25 Deceleration on slowing down M1
P26 Deceleration on slowing down M2
P27 -
P28 -
34
Press the button until you
see the parameter to be
modified
Settable values
ON/OFF
0-600 seconds
1= when opening, AP/CH input not active
(condo)
2=AP/CH as sequential (open, stop, close, stop..)
3=AP/CH as sequential (open, open, close..)
ON/OFF
ON/OFF
1= photocell as protection on opening
(if engaged it stops the gate, until it is disengaged, and then it contin-
ues opening)
2= microswitch sensitive edge
3= resistive sensitive edge (balanced with resistance (8.2Kohm)
ON = slow flash during opening, steady with gate open, fast flash
during closing
OFF = on steady while moving and with gate open, and off when the
gate is closed
OFF= Control disabled, 1= Control on PHOTO input
2= Control on STPA input, 3= Control on STPA and PHOTO inputs
From 0 to 100% of travel
From 0 to 100% of travel
From 0 to 100% of travel
From 0 to 100% of travel
From 50 to 100%
From 50 to 100%
From 50 to 100%
From 50 to 100%
(15 - 75 with encoder), (35 - 70 without encoder)
(15 - 75 with encoder), (35 - 70 without encoder)
(15 - 75 with encoder), (35 - 70 without encoder)
(15 - 75 with encoder), (35 - 70 without encoder)
From 1 minimum to 10 maximum
From 1 minimum to 10 maximum
1-5 ( 1=maximum acceleration 5= minimum acceleration)
1-5 ( 1=maximum acceleration 5= minimum acceleration)
1-8 ( 8= maximum deceleration 1= minimum deceleration)
1-8 ( 8= maximum deceleration 1= minimum deceleration)
Default Modified
value value
ON
60 sec-
onds
1
ON
OFF
1
ON
OFF
30%
30%
70%
70%
100%
100%
100%
100%
50%
50%
50%
50%
5
5
3
3
6
6
EN