Look C-STEM Manual De Montaje página 14

GB
ASSEMBLING & MOUNTING (Continued)
3. Insert the fork's pivot in the oblong of the
stem's body (3), between the shells in the
alignment of the wheel.
If you have trouble inserting the fork's pivot,
make sure that the stops are in the right
position.
Warning!
Make sure that the fork's pivot rests on
the shells' stops (7) before tightening!
In the following steps, make sure to lubricate
the stopper+screw and the tapped stopper
unit before mounting!
4. Place the stopper+screw unit in its housing in
the stem's body (3). (Fig 5)
5. Place the second stopper in its housing.
Note (Also see appendix):
• If you wish to reach the following
positions: -9° / -5° / -1° / +3° / +7° / +11°,
insert the stopper+screw unit in the RIGHT
SIDE housing of the stem's body (3)
14 14
• If you wish to reach the following
positions: -7° / -3° / +1° / +5° / +9° / +13°,
insert the stopper+screw unit in the RIGHT
SIDE housing of the stem's body (3)
6. Insert the hex head key into the M8 screw.
7. Slightly tighten the M8 screw so as to
adjust the stem's height setting.
8. Once the desired position reached,
tighten the screw at the maximum torque
indicated.
9. Place one of the side cover plates (6) to
rest on the thread insert (10). Tighten with
the M3 screw (11). Insert the unit in the M8
screw. Place the second cover plate on
the other side of the stem and tighten the
second M3 screw at the specified torque.
10. Insert the handlebars in their housing and
tighten the four cover screws (1)
Fig 5
progressively and crosswise (Fig 6).
1
3
Fig 6
2
4