6
Installation
1
7
KKS/043
Figure 12 Valve unit holder,
screw-in connector inserted,
view 1
Insert the screw-in connector (7) in the holder (1), making
sure that the shorter threads are on the same side, as shown
in Figure 12.
Fit the hex nut (8) to the long thread and turn by hand until it
is nearly in contact with the holder, as shown in Figure 13.
ADVICE!
See Figure 9 for an overview of components.
8
KKS-044
Figure 13: Valve unit holder,
screw-in connector inserted,
view 2
MUB 007 004 M01 (REV--) 05-2023
10
9
8
Figure 14: Valve unit holder, fitting the seals
Fit another hex nut (8) to the long thread and turn by hand.
Push one thrust collar (9) and washer (10) onto the long
thread, and do the same on the short thread (see Figure 14).
ATTENTION!
Take care not to damage washers and thrust collars.
Make sure that the flat side of the thrust collar is in con-
tact with the hex nut (8) and the other side is in contact
with the hexagon of the screw-in connector (7).
9
10
KKS/045
65