JOST KKS-U Instrucciones De Montaje Y Funcionamiento página 66

6 Installation
Figure 15: Valve unit holder, installing the line filters
Fit the line filters (5) to the connection side of the holder (1),
which is facing the front in the direction of travel and there-
fore has the smallest distance from the KKS system. Use con-
nection 2 of the line filters and fit them to the screw-in con-
nectors (7). Securely tighten the line filters (see Figure 15).
IMPORTANT!
After installation, the opening of the line filters must
face downwards.
ADVICE!
See Figure 9 for an overview of components.
66
Figure 16: Valve unit holder, installing the 2-way valve
Connect the 2-way valves (6) to the unused connection side
of the screw-in connectors (7). Use port 1.1 of the 2-way
valves (6) to do this. Align the 2-way valves so that port 2 is
horizontal and facing the semi-trailer chassis (see Figure 16).
MUB 007 004 M01 (REV--) 05-2023
ATTENTION!
Do not screw ports 1.2 and 2 of the 2-way valve to the
screw-in connector (7) during this step.