Craftsman 126.32565 Manual Del Operador página 23

2.Place a combination square o nthemiter 6.Use anAllen Key toturn thescrew inor
table withtheruleagainst thetable and the outtoadjust theblade angle.
heel o fthesquare a gainst theblade. (Fig. N ) (Fig.P1&P2)
(Fig. N)
3. If the blade is not 900 square with the miter
table, adjustment is required.
4. Loosen the Bevel Lock Handle and tilt the
Cutting Head to the left.
5. Loosen the Iocknut on the Bevel Angle
Adjustment Screw. (Fig. P)
(Fig. P1 & P2)
7. Return the Cutting Head to its upright
position and recheck angular alignment
against the combination square.
8. Repeat steps 1 to 7 until correct angular
alignment is achieved.
9. Tighten the Bevel Angle Adjustment Screw
Iocknut securely.
0° Bevel Pointer Adjustment
NOTE: The operator must be satisfied that
the blade is exactly perpendicular to the table
when in the upright position and against its
stop.
1. If the pointer is not in exact alignment
with the 0° mark on the protractor scale
adjustment is necessary.
2. Loosen the Bevel Pointer screw using a #2
Phillips screwdriver.
3. Adjust the Bevel Pointer so that it is in
alignment exactly with the 0° mark.
4. Retighten the screw.
(Fig. P)
23