Craftsman 126.32565 Manual Del Operador página 25

2. If adjustment is necessary, loosen the two
Fence adjustment screws using an Allen Key.
3. Re-position the Fence on its elongated
slots until alignment is achieved.
4. Securely tighten the socket head screws.
Miter Angle Pointer Adjustment
NOTE: There are dual miter angle scales
cast into the rotary table to the right hand
side of the blade. A small pointer indicates
the angle selected.
If necessary the pointer can be repositioned
by loosening its fastening screw using a #2
Phillips screwdriver.
Adjust as necessary, then securely tighten
the fixing screw.
CUTTING HEAD TRAVEL
Cutting Head Downward Travel
Adjustment (Fig. S)
To prevent the blade from contacting any part
of the machines base, the downward travel
of the Cutting Head can be adjusted.
Lower the Cutting Head and check for any
blade contact with the machine base or table
insert.
If the downward travel of the Cutting Head
needs to be adjusted:
1. Loosen the Iocknut on the downward
travel stop screw.
2. Turn the adjusting screw out
(counterclockwise) to decrease the
downward travel of the Cutting Head.
3. Turn the adjusting screw in (clockwise) to
increase the downward travel of the Cutting
Head.
4. Tighten the adjustment screw Iocknut
when satisfactory downward travel of the
Cutting Head is achieved.
(Fig. S)
25