Publicidad
Idiomas disponibles
Idiomas disponibles
45 o Bevel Stop Adjustment
1. Loosen the Bevel Lock Handle and tilt the
Cutting Head completely to the left until it
rests against the 450 stop.
2. Use a combination square to see if the
blade is at 450 to the table.
3. If the saw blade is not in exact alignment
adjustment is necessary.
4. Return the Cutting Head to its upright
position.
5. Loosen the Iocknut on the 456 Bevel
Adjustment Screw.
6. Use an Allen Key to turn the Adjustment
Screw in or out as required. (Fig. Q)
7. Tilt the Cutting Head to the 45 osetting and
recheck for alignment with the combination
square.
8. Repeat steps 1 to 7 until the correct
angular alignment is achieved.
9. Tighten the Adjustment Screw Iocknut
securely once alignment is achieved.
_, WARNING
When all angular adjustments
have been
successfully completed, the procedure of
the lower safety guard must be checked
to ensure that it is working correctly.
The saw must not be used if the lower
safety guard is not operating correctly.
Fence Adjustment
The fence must be aligned at 90o (square)
to a correctly installed blade The rotary table
must be set at '0 °' miter angle.
The Fence is fastened to the table with two
socket head Allen screws that are positioned
one at either side in elongated slots.
1. Place a combination square on the table
with the rule against the Fence and the heel
against the Blade. (Fig. R)
(Fig. Q)
(Fig. R)
24
Publicidad
