Craftsman 126.32565 Manual Del Operador página 37

TROUBLESHOOTING GUIDE - SAW OPERATION
PROBLEM PROBLEM CAUSE SUGGESTED CORRECTIVE
ACTION
Blade hits the table or table 1. INCORRECTLY INSTALLED BLADE• 1. CHECK BLADE INSTALLATION• SEE
insert. INSTALLING OR REMOVING A
BLADE SECTION•
Cutting head wobbles•
1. Loose PIVOT BOLT• 1. CONTACT SEARS SERVICE CENTER•
1. DEFECTIVE, DAMAGED OR BRO- 1. CONTACT SEARS SERVICE CENTER•
KEN PIVOT SPRING•
Cutting Head will not fully
raise, or the blade guard
fully close•
Blade binds, jams or burns
workpiece.
Excessive vibration•
2.DEBRIS BUILD-UP.
1
• gULL, DAMAGED OR WARPED
BLADE•
2.
WRONG BLADE FITTED•
3. INCORRECT OPERATION••
4. WORKPIECE NOT SECURE•
1. SAW BLADE DAMAGED, LOOSE OR
NOT BALANCED•
2.
ARBOR BOLT LOOSE•
2.
CLEAN DEBRIS AND LUBRICATE GUARD
OPERATING ARM PIVOTS•
SEE MAINTENANCE SECTION•
1.
REPLACE THE BLADE• SEE
INSTALLING OR REMOVING A
BLADE SECTION•
2. As ABOVE•
3. SEE BASIC SAW OPERATIONS
SECTION.
4. SECURE THE WORKPIECE TO THE
TABLE AND FENCE WITH A HOLD DOWN
CLAMP OR SIMILAR.
1.
REPLACE THE BLADE• SEE
INSTALLING OR REMOVING A
BLADE SECTION•
2.
TIGHTEN THE ARBOUR BOLT. SEE
ABOVE.
37