Installation; Important - Corghi EYELIGHT Plus Diagnostic Line Manual De Uso

CAUTION
Never apply force to the wheel spin shaft when
moving the machine.

INSTALLATION

WARNING
Carry out the unpacking, assembly and installa-
tion operations indicated below with great care.
Failure to comply with these instructions could
damage the machine and put the operator at risk.
Remove the original packing materials after
positioning them as indicated on the packaging
and keep them intact so that the machine can
be safely shipped at a later date if necessary.
WARNING
The place where the machine is to be installed
must conform to applicable safety at work
regulations.
In particular, the machine must only be installed
and used in protected environments where
there is no risk of dripping onto it.
The floor must be strong enough to support a
load equal to the weight of the equipment plus
the maximum load allowed. The support base on
the floor and the envisaged fixing means must
also be taken into account.

IMPORTANT:

for the correct and safe operation of the machine,
the lighting level in the place of use should be
at least 300 lux.
Environmental operating conditions must comply
with the following requirements:
- Relative humidity ranging from 30% to 80%
(without condensation).
- Temperature ranging from 5° to +40°C.
WARNING
The machine must not be operated in potentially
explosive atmospheres.
The machine is supplied partially disassembled
and is to be assembled according to the proce-
dures described below.
46
In order to maintain the appearance and perfect
working order of the display, regularly clean the
screen as follows:
- switch off the machine;
- clean the screen using specific products or a
soft damp cloth. You can use a detergent for
glass but do not spray the detergent directly on
the surface of the display;
- if there is also dust or dirt along the infrared
frame of the monitor, it is recommended to
blow compressed air along the four sides of the
monitor and in the corners, paying particular
attention to the lower side where dust tends to
settle more;
- switch on the machine and wait, after display
of the main logo, for about 30 seconds to allow
the monitor to execute auto-calibration.
CAUTION
If during operation the machine displays the
auto-calibration of the monitor to terminate
without using it and as soon as possible clean
the monitor as indicated in the paragraph
"Touchscreen monitor cleaning"
Monitor support and monitor
- fix the monitor support (A, fig.4) to the weight
tray and to the casing using the six screws sup-
plied with the machine (fig.4);
- insert the monitor's USB cable, the signal cable
and the power supply cable inside the previ-
ously mounted support, as shown in figure 5;
- fix the closing plate (A, fig.5) using the eight
screws (V, fig.5) supplied with the machine;
- Remove the monitor from its packaging and
remove the support base, if necessary.
- Fix the monitor to the wheel balancer support
flange using the four screws supplied with the
machine (A, fig 6).
- connect the USB, signal and power supply
cables to the rear monitor panel (B,C,D, fig. 6).
EYELIGHT Plus DiagnosticLine - Operator's manual
Touchscreen monitor cleaning
icon, wait a few seconds for
touchscreen assembly