General Conditions Of Use; Switching On The Machine - Corghi EYELIGHT Plus Diagnostic Line Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

GENERAL CONDITIONS OF
The equipment is intended for professional use only.
WARNING
Only one operator at a time can work with the
machine.
The wheel balancers described in this manual
must be used exclusively to measure the extent
and position of car wheel unbalances, within the
limits specified in the Technical specification sec-
tion. Furthermore, models equipped with motors
must be provided with a suitable guard, fitted with
a safety device, which must be lowered during the
spin operation.
WARNING
Any use of the machine other than the described use
is to be considered as improper and unreasonable.
CAUTION
Do not start the machine without the wheel lock-
ing equipment.
WARNING
Do not use the machine without the guard and do
not tamper with the safety device.
CAUTION
Do not clean or wash the wheels mounted on the
machine with compressed air or jets of water.
WARNING
It is advisable to use only original tools for working.
WARNING
Get to know your machine: The best way to prevent
accidents and obtain top performance from the
machine is to ensure that all operators know how
the machine works.
Learn the set up of all controls and their functions.
52
USE
EYELIGHT Plus DiagnosticLine - Operator's manual
Accurately check for correct functioning of every
machine control device. To prevent accidents
and personal injury, all the equipment must be
correctly installed, correctly operated and cor-
rectly serviced.
POSITION OF THE OPERATOR
The following figure shows the positions occupied
by the operator during the various work phases:
A Mounting / disassembling operations, launch,
dimension detection (where provided) and
wheel balancing
B Machine programs selection
In this way, the operator is able to perform,
monitor and verify the outcome of each wheel
balancing and intervene in case of unforeseen
events.
SWITCHING ON THE
MACHINE
Connect the power supply cable (A, Fig. 11a) sup-
plied with the machine from the external electrical
panel located on the rear side of the wheel balancer
body to the mains.
A
11a

Publicidad

Tabla de contenido
loading

Tabla de contenido