-
Hold down the stop
the keypad for at least 3 seconds or go to the
utility and configuration programmes, then
press the icon
wheel-holder shaft and the internal devices.
-
Insert the C special key provided with the
machine in the C hub hole (Fig. 12).
- Unscrew the C hub completely.
- Mount the flange on the shaft and lock it with the
two screws (A, Fig. 13) using the CH 6 wrench.
A
- Lock the wheel onto the flange as usual.
C hub mounting
Proceed as follows to remount the C hub:
-
Hold down the stop button
for at least 3 seconds or go to the utility and
58
button on
-
-
to block the
-
12
The machine can be fitted with the WINUT device
- i.e. the activation of the automatic wheel locking
device C via the button on the sleeve C (Fig.14a)
rather than via the control pedal (M, Fig.10).
13
This device can also be fitted on other machines,
by requesting the relevant accessory.
On the work screen, the machine visualises
certain icons relating to the device:
-
EYELIGHT Plus DiagnosticLine - Operator's manual
configuration programmes, then press the
icon
to block the wheel-holder
shaft and the internal clutch.
Screw the C hub manually until it reaches the
end position.
Tighten the C hub by inserting the C special
wrench into the C hub hole (Fig. 14).
To tighten the hub properly, a hammer stroke
must be used on the special C key (it is also
possible to use the caliper, hammer side, to
secure the spring weights).
WINUT DEVICE
: indicates that the machine rec-
14
14a