Corghi EYELIGHT Plus Diagnostic Line Manual De Uso página 60

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

may spin with the guard raised.
NOTE
If the width measurement is highlighted in
red, it means that one of the automatic control
parameters has not been met and it is therefore
advisable to check the dimension. Using the
touch screen select, if necessary, the feedback
window and manually enter the nominal width
of the rim, press enter and exit the manual entry
mode.
NOTE
If the laser sensors and/or telecamera fails to
operate, the geometric data can be entered
manually by following the procedure indicated
in the "Manual wheel data entry" section. This
function is present in the Utility and Configura-
tion programmes.
NOTE
The laser sensors may not measure the rim
dimensions correctly on particularly reflective
surfaces. In this case enter the geometric data
manually following the procedure described in
the paragraph "Manual wheel data entry", which
is a function present in the Utility and Configura-
tion programmes. In this circumstance, at the end
of the spin, the machine will automatically set
up so the diameter can be entered (see figure),
whereas the distance and width are present but
must be checked for correctness and changed if
necessary. The balancing weights must always be
applied at 12 o'clock, regardless of the selected
programme.
60
CAUTION
bear in mind that the nominal wheel diameter
(e.g. 14") refers to the planes on which the tyre
beads rest which are obviously inside the rim.
On the other hand, the data measured refer to
external planes, so they will be lower than the
rated values because of the thickness of the
rim. The correction value therefore refers to an
average thickness of the rim. This means that the
data measured on wheels with different thick-
nesses may vary slightly (2 or 3 tenths of an inch
maximum) from the rated values. This is not a
lack of accuracy of the measuring devices, but
reflects reality.
Do not operate the machine without the guard
and/or if the safety device has been tampered
with.
Never raise the guard before the wheel has
come to a stop.
At the end of the spin, the machine will open the
wheel guard automatically, therefore do NOT
stand in the range of operation of the guard.
If the wheel keeps spinning permanently due to a
fault on the machine, switch off the machine using
the main switch or disconnect the plug from the
power supply board (emergency stop) and wait
EYELIGHT Plus DiagnosticLine - Operator's manual
WARNING
WARNING
WARNING
WARNING

Publicidad

Tabla de contenido
loading

Tabla de contenido