Changing The Rear Light Bulb - APRILIA RS 125 Tuono 2003 Manual Del Usuario

RS 125 Tuono_Ing_book_my03.book Page 75 Tuesday, April 29, 2003 3:11 PM
Upon reassembly, correctly po-
sition the protection screen in its
seat.
Tighten the screw (16) moderately and
carefully, to avoid damaging the protec-
tion screen.
N Press the bulb (18) slightly and rotate it
anticlockwise.
N Extract the bulb from its seat.
Insert the bulb in the bulb sock-
et, making the two bulb pins co-
incide with the relevant guides on the
socket.
Correctly install a new bulb of the same
N
type.
If the bulb socket (19) goes out
of its seat, insert it correctly,
making the bulb socket opening coin-
cide with the screw seat.
CHANGING
THE REAR LIGHT BULB
Carefully read page 73 (BULBS).
Before changing a bulb, check
the fuses, see page 69 (CHANG-
ING THE FUSES) and the effective oper-
ation of the stoplight switches, see
page 71 (CHECKING THE SWITCHES).
Position the vehicle on the stand.
N
N Unscrew and remove the two screws (1).
Remove the protection screen (2).
N
Upon reassembly, correctly po-
sition the protection screen in its
seat.
Tighten the screw (1) carefully, without
exerting too much pressure, in order to
avoid damaging the protection screen.
N Press the bulb (3) slightly and rotate it
anticlockwise.
N Extract the bulb from its seat.
Insert the bulb in the bulb soc-
ket, making the two bulb pins
coincide with the relevant guides on the
socket.
N Correctly install a new bulb of the same
type.
Upon reassembly, tighten the
two screws (1) moderately and
carefully, to avoid damaging the
protection screen.
use and maintenance RS 125 Tuono
75